Prototype Microphone Audio Board - Seraph Pro (XLR Output Only)

This is a prototype version of the microphone audio board used in the Seraph Pro. While functionally similar to the final production model, it has one known issue: the 3.5mm output is attenuated in a way that introduces excessive noise.  If you have soldering experience, you may be able to repair this output manually by removing some resistors and bridging solder pads.  Otherwise, it is intended for XLR output use only.

Please note: This board is not recommended as a replacement for the stock audio board in the Seraph Pro.

A Dead on Arrival (DOA) warranty only is provided.  No support will be offered for modifications or damage caused by improper use.

Only 100 units were produced. Once sold out, they will not be restocked.

Buy 3 and receive 10% off automatically.

Buy 5 and receive 25% off automatically.

Features

• Dual matched 5V electret microphone Burr-Brown op-amp preamp circuits
• +48V Phantom Power compatible (XLR output)
• Accepts regulated 5.1V DC input via center JST-PH 2.0mm connector
• Low Cut Off(High-Pass) Filter

Requirements

• 2x Electret microphone capsules (5V compatible)

Included

• 1x Prototype Audio Board
• 4x Mounting Screws
• 3x JST-PH 2.0mm wire leads